PEG-12 Dimethicone in cosmetics: water-soluble silicone, safety
PEG-12 dimethicone is a “water-soluble” silicone often found in hair conditioning sprays and water-based hair serums. This article checks it against verified sources: its definition, manufacturing impurities, the few studies available, the concentrations companies have reported, the CIR safety conclusion and its status in the ASEAN annexes.
PEG-12 dimethicone is a modified silicone: a dimethicone backbone carrying polyethylene glycol (PEG) chains with an average of 12 ethylene oxide units, which makes it water-soluble. It is listed as a hair-conditioning and skin-conditioning agent; more than half of the uses reported in the CIR report are in hair products. The CIR (Cosmetic Ingredient Review, US) Expert Panel concluded that it is safe in the present practices of use and at the concentrations surveyed.
1. What is PEG-12 dimethicone?
The INCI definition quoted in the CIR report (2015): “the polyethylene glycol derivative of dimethicone containing an average of 12 moles of ethylene oxide”; its listed functions are hair-conditioning agent and skin-conditioning agent. CAS No. 68937-54-2 is a generic number for dimethylsiloxane–ethylene oxide copolymers, not specific to PEG-12 dimethicone. As a polymer, it has no defined molecular formula; PubChem has no compound record for this name.
The “12” describes only the PEG chain; molecular size depends mainly on the silicone portion, so grades with the same INCI name can differ (the report gives 500–1,000 g/mol from one source and about 3,000 g/mol from another). The PEG chains can be attached along the side of the backbone or at both chain ends. The grades are described as colorless to yellow liquids, completely soluble in water and soluble in ethanol; some grades are insoluble in mineral oil.
This is what sets it apart from dimethicone (in Vietnamese), which is hydrophobic, and from amodimethicone (in Vietnamese), a silicone carrying amine groups that usually comes as an emulsion. In formulation practice, PEG-12 dimethicone is chosen when a silicone is needed in a clear water-based product such as a hair conditioning spray.
2. Manufacturing and impurities to check
According to CIR, this group is made by hydrosilylation: an allyl-terminated polyether is attached to dimethicone. The reaction requires excess polyether, so the material typically still contains 10–30% unreacted polyether (by weight) and is essentially a mixture; removing the excess is considered not feasible because it reduces performance. For PEG-12 dimethicone, one supplier reported that the material contains 30–40% allyl-terminated polyether, with D4 and D5 below 0.1%. The CIR Panel concluded that the residues are not a concern because the toxicity tests, which were performed on material already containing the residues, were all negative.
1,4-dioxane and ethylene oxide. The CIR report has no data on these two impurities for the PEGylated silicones. However, the PEG chains are made from ethylene oxide, and the SCCS (the EU Scientific Committee on Consumer Safety) notes that 1,4-dioxane may form as a by-product in the manufacture of ethoxylated substances, especially surfactants and emulsifiers. Requesting a COA that includes 1,4-dioxane for each lot is therefore a prudent practice (an inference from general sources; no specific measured data are available). The ASEAN Guidelines on Limits of Contaminants for Cosmetics (version 3.0) set 1,4-dioxane at no more than 10 ppm from June 19, 2023, applicable when finished products are analyzed in post-market surveillance (see also the article on PEG-100 stearate (in Vietnamese)).
3. Role in formulas and current evidence
Published data specific to PEG-12 dimethicone are scarce: a PubMed search (November 22, 2026) for “PEG-12 dimethicone” returned 6 articles, mostly formulation studies and experiments on hair tresses or excised animal skin; there are no efficacy trials in humans. Level of evidence: limited.
| Study | Design | Results as reported by the source | Notes |
|---|---|---|---|
| da Gama et al., 2018 | Caucasian human hair tresses dyed with an oxidative hair dye emulsion with or without a conditioning agent; n = 15 | Samples with PEG-12 dimethicone lost less protein than samples dyed without a conditioning agent (though still more than undyed hair); dry combing results did not differ significantly from untreated hair; breaking strength did not differ between samples | In vitro; the abstract does not state the concentration |
| Andrade et al., 2007 | Oil-in-water emulsions containing lamellar liquid crystals | Adding PEG-12 dimethicone did not change the liquid crystal phase under the microscope and reduced viscosity; zeta potential ranged from −39.7 to −70.0 mV; the authors concluded that it had a positive effect on stability | Formulation study |
| Uyama et al., 2022 | Neutron scattering combined with rheology measurements | PEG-12 dimethicone can form a lamellar liquid crystal phase; at concentrations of 36% by weight and above, the lamellar structure was seen to reorient, with almost no transition to vesicles | Physicochemical; some authors are affiliated with a cosmetics company |
| Lademann et al., 2020 | Pilot experiment on excised pig ear skin | Spraying PEG-12 dimethicone onto the skin before blotting with a nanofiber textile helped remove soot particles of about 600 nm from the skin more effectively | Ex vivo; includes an industry co-author |
| Industry data submitted to CIR (unpublished) | 24-hour occlusive patch on 53 people (48 women, 5 men) | PEG-12 dimethicone at 0.5%, 2% and 5% applied together with 1% SLS reduced irritation compared with SLS alone; the 5% level gave the greatest reduction | Safety test, not an efficacy test |
Claims such as “smoothing”, “detangling” and “lightweight on hair” should therefore be substantiated on the finished product (combing force, sensory evaluation).
4. Reported concentrations and product types
The CIR report compiles the number of uses from the FDA Voluntary Cosmetic Registration Program and the maximum concentrations reported by companies in a survey by the US Personal Care Products Council (October 2014). PEG-12 dimethicone has the highest number of uses in the group. These are reported levels, not recommended levels:
| Category | Number of uses | Maximum reported concentration |
|---|---|---|
| Total | 538 | 0.0016–6.5% |
| Leave-on | 315 | 0.0016–6.5% |
| Rinse-off | 220 | 0.1–5% |
| Diluted for bath use | 3 | 0.5–1% |
| Hair products (non-coloring) | 288 | 0.01–5% |
| Hair dyes | 9 | 0.1–1% |
| Eye area | 10 | 0.0016–2% |
| Mucous membranes | 79 | 0.5–3% |
| Baby products | 6 | 4% |
| Hair spray, aerosol / pump | — | 0.1–2% / 0.15–0.5% |
5. Safety
CIR conclusion. In 1982, CIR concluded that the “dimethicone copolyol” group was safe as used; a re-review published in 2005 upheld the conclusion and listed PEG-12 dimethicone under its new INCI name. The final report released on January 14, 2015 (111 ingredients) concluded that they “are safe in cosmetics in the present practices of use and concentration described in this safety assessment”.
- Absorption: the Panel considered these to be macromolecules that are not expected to penetrate the skin.
- Skin: in rabbits, the undiluted material applied under a semi-occlusive patch for 4 hours caused very slight erythema that cleared within 72 hours. Repeated application for 29 days (up to 1,000 mg/kg, 6 hours/day) caused no systemic toxicity, but the incidence of local erythema increased with dose; one animal had severe (reversible) erythema, and ulceration at the application site occurred in female rabbits of the low- and mid-dose groups. In a reconstructed human epidermis model: non-irritating.
- Sensitization: a Magnusson–Kligman test in guinea pigs showed no sensitization. The CIR report contains no human repeated insult patch test (HRIPT) specifically for PEG-12 dimethicone.
- Eyes: instillation into rabbit eyes on 5 consecutive days showed no signs of corneal or iris irritation; there was mild, transient conjunctival redness after each instillation. Mixing with SLS reduced eye irritation compared with SLS alone.
- Inhalation: rats exposed to 0.68 mg/L by inhalation for 4 hours showed no deaths and no abnormalities. CIR considered that incidental inhalation from spray products is not a significant route of exposure at the concentrations in use.
- Other toxicity (animals): oral, 29 days, no-observed-adverse-effect level of 1,000 mg/kg/day (rats); not mutagenic in the Ames test; dermal application to pregnant rabbits at up to 200 mg/kg caused no embryotoxicity or malformations.
- Pregnancy and breastfeeding: the data above are from animals; human data are insufficient, so consult a doctor.
6. Does it build up on hair? Can the product be labeled “silicone-free”?
The review by Carvalho et al. (2025) raises concerns about buildup from water-insoluble silicones, which require stronger surfactants to wash out; water-dispersible silicone systems are one approach to reducing this problem. Because PEG-12 dimethicone is water-soluble, it should in theory rinse off more easily than hydrophobic silicones, but there are no measurements of residue on hair for this ingredient specifically.
On labeling: PEG-12 dimethicone is still a silicone (it has a dimethicone backbone), so products containing it should not be labeled “silicone-free”; an analysis of the regulations on “free-from” claims is in the amodimethicone article linked in section 1.
7. Notes for brand owners (B2B)
- ASEAN regulations: a search of Annexes II, III, VI (version 2026-1, June 22, 2026) and VII (version 2025-2) by name, by the strings “methicone”, “siloxane” and “silicone”, and by CAS 68937-54-2 found no entry for PEG-12 dimethicone, so there is no specific concentration limit or label warning. Related impurities listed in Annex II: D4 (Ref 1388, “Octamethylcyclotetrasiloxane; D4”), ethylene oxide (Ref 182), dioxane (Ref 343). For exports to the EU: see the rules on D4, D5 and D6 in the article on cyclopentasiloxane (D5) (in Vietnamese).
- Raw material documentation: the technical data sheet states the structure type, molecular weight and free polyether content; the COA covers D4, D5 and 1,4-dioxane for each lot.
- Formulation (to be tested in the formula): dissolve it in the water phase. CIR notes that the longer the PEG chain, the higher the foaming ability and the cloud point (the temperature at which the solution starts to separate into two phases) — for clear solutions, check clarity during hot storage; for shampoos and shower gels, retest the foam.
- Sprays: the CIR conclusion is based on current use levels (aerosol hair sprays up to 2%, pump sprays up to 0.5%); going above these levels requires a separate safety assessment.
- Claims: use “helps leave hair soft and smooth, easy to comb” and “reduces frizz and tangles” once tested on the finished product; avoid “repairs damaged hair”, “no buildup”, “silicone-free” and “safe for pregnant women”.
Butter-C uses PEG-12 dimethicone in some contract-manufactured hair conditioning spray and hair serum formulas.
Frequently asked questions
Is PEG-12 dimethicone a silicone?
Yes. It is dimethicone with PEG chains attached; it is water-soluble but still a silicone.
Does PEG-12 dimethicone make hair limp and greasy, or build up?
There are no specific measurements yet; repeated-use testing on the finished product is advisable, especially for fine hair.
Does PEG-12 dimethicone contain 1,4-dioxane?
Traces may be present because the PEG chains are made from ethylene oxide; check it with a COA for each lot. The ASEAN guidelines set a limit of no more than 10 ppm in finished products.
Does this ingredient cause irritation or make the eyes sting?
CIR concluded that it is safe in the present practices of use; in rabbits it caused only mild, transient conjunctival redness. If it gets into the eyes, rinse with clean water.
Can pregnant women use products containing PEG-12 dimethicone?
Human data are insufficient; consult a doctor.
References
- Cosmetic Ingredient Review. Safety Assessment of Polyoxyalkylene Siloxane Copolymers, Alkyl-Polyoxyalkylene Siloxane Copolymers, and Related Ingredients as Used in Cosmetics (Final Report, released January 14, 2015). https://www.cir-safety.org/sites/default/files/ROPSIL_122014%20_FAR.pdf
- da Gama RM et al. Protective effect of conditioner agents on hair treated with oxidative hair dye. J Cosmet Dermatol. 2018. PMID 29316174
- Andrade FF et al. Influence of PEG-12 Dimethicone addition on stability and formation of emulsions containing liquid crystal. Int J Cosmet Sci. 2007. PMID 18489351
- Uyama M et al. Neutron Reflectometry & Simultaneous Measurements of Rheology and Small Angle Neutron Scattering Studies for Polyether Modified Silicone Vesicle Systems. J Oleo Sci. 2022. PMID 36198585
- Lademann J et al. Laser scanning microscopy for control of skin decontamination efficacy from airborne particulates using highly absorbent textile nanofiber material in combination with PEG-12 dimethicone. Skin Res Technol. 2020. PMID 31919922
- Carvalho RM et al. With or without Silicones? A Comprehensive Review of Their Role in Hair Care. Skin Appendage Disord. 2025. PMID 40641805
- SCCS. Opinion on the Report of the ICCR Working Group: Considerations on Acceptable Trace Level of 1,4-Dioxane in Cosmetic Products (SCCS/1570/15). 2015. https://ec.europa.eu/health/scientific_committees/consumer_safety/docs/sccs_o_194.pdf
- ASEAN Cosmetic Committee. ASEAN Guidelines on Limits of Contaminants for Cosmetics (Release Version 3.0). https://file.go.gov.sg/asean-guidelines-on-limits-of-contaminants-for-cosmetics.pdf
BUTTER-C